Well Tempered Lab Amadeus Bedienerhandbuch PDF herunterladen (Seite 7)

Installing the Platter

Please ensure that the point of the triangle hold in the upper teflon bearing is correctly orientated to

the motor pulley. See Fig (10). If necessary consult your dealer.

Fill the bearing with synthetic oil supplied to a level of approx 5mm (1/4”) above the bottom Teflon

bearing, this is not critical. Do not overfill. Over-filling the bearing will cause the oil to overflow the

bearing housing when the platter spindle is lowered into the bearing housing. Gently lower platter into

bearing. See Fig (11) - (12). It is most important that spindle is located correctly in the centre of the

lower thrust bearing. Failure to locate the pivot point of the spindle correctly will cause the platter to

rotate abnormally. The spindle has been designed to protrude through the platter to provide a central

lifting point that enables the user to easily achieve this.

Important: The unique design of the zero clearance Well Tempered Lab top bearing allows the

spindle to be virtually “free standing”. It is perfectly normal for the platter to tilt away from the motor

when the belt has not been installed.

Should there be any necessity to replace the bearing oil, any synthetic motor oil of any brand within a

viscosity range of 5W-50 is acceptable.

Note: The zero clearance Well Tempered bearing can rotate for hours without oil. If you wish, you

can complete other adjustments before applying the bearing oil. See Fig (10).

Fig (11)

Fig (10)

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Keine Kommentare

Well Tempered Lab Amadeus Bedienerhandbuch Seite 7